Follow

Solectria Inverter Configuration and Wiring

Solectria PVI60kW - PVI82kW - PVI95kW

If the SolrenView module is installed on the inside of the inverter door, this means RS-485 is enabled. Note that the cover to the module must be removed to alter the state of the DIP switches enabling/disabling the terminating resistors. Finally, keep in mind that these inverters speak at Baud Rate 19200, so be certain to enable this in the AcquiSuite and pay careful attention when using with a ModHopper as the ModHopper can only speak 9600 OR 19200.

Select the 'Solectria' template when configuring a device in the AcquiSuite's Device List.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Article is closed for comments.
Powered by Zendesk